All Products

LMR-195 and LMR-200 Cable Prep Tool Learn More

TIMES TNC Male Right Angle Crimp connector for LMR-400 coaxial cable. Nickel body, Silver center pin. Teflon dielectric. DOES NOT WORK ON 400-UF. Learn More

TIMES Mini-UHF male crimp connector for LMR- 200 cable. Silver plated bodies, gold center pin. Solder center pin, Crimp on braid. Learn More

The Times Microwave LMR-600 1/2 inch standard coax cable with foam dielectric has a UV-resistant Polyethylene jacket for outdoor use. The Times Microwave LMR-600 1/2 inch foam coaxial cable is available in bulk and is priced per foot. Learn More

The Times Microwave LMR-200 low loss braided coaxial cable offers similar performance compared to corrugated copper cables but provides higher flexibility and simplified connectorization. available in bulk and sold per foot. Learn More

TIMES MICROWAVE 20-1000 MHz general coverage bulkhead and flange mt. 10KA surge. <200uJ throughput energy. N/F connectors. IP67 weatherized. Learn More

The RFS ICA12-50JPLW 1/2 inch plenum-rated coaxial cable features an air dielectric. The 50 Ohms coax cable has a white jacket. This air dielectric cable has an annular corrugated copper outer conductor and copper-clad aluminum inner conductor. Maximum frequency capacity is 6.0 GHz. This transmission line uses 1/2 inch standard connectors. The RFS 1/2 inch plenum-rated coaxial cable with air dielectric is available in bulk and is priced per foot. Learn More

TIMES MICROWAVE DC - 2.5 GHz 3/8" LMR400-75 coax cable. 75 ohm. Lower loss than RG11. Uses LMR400-75 connectors only. Learn More

TIMES MICROWAVE DC - 2.5 GHz 1/2" LMR600-75 coax cable. 75 ohm. Lower loss than RG11. Uses LMR600-75 connectors only. Learn More

TIMES reverse polarity TNC male (Female) for LMR400 coaxial cable. Meets FCC specs for use with Spread Spectrum technology. Crimp type. DOES NOT WORK WI Learn More

TIMES TNC male Advantage connector for LMR-400. Gold pin. Silver plate body, gold center pin. No braid trim. Learn More

TIMES MICROWAVE All-In-One Combination Prep Tool for prep of LMR240 cables for crimp or clamp connectors. Learn More

The Times Microwave LMR-200-DB direct burial low loss RG58 coaxial cable has the advantage of being watertight. This 3/16 inch 50 Ohm coax cable offers similar performance compared to corrugated copper cable but provides higher flexibility and simplified connectorization. The braided coaxial cable has a 1/2 inch bending radius.The RG58 cable can be used in almost any application where handling characteristics, improved shielding and low loss are required. The LMR-200 cable has a stranded outer conductor and a copper-clad aluminum center conductor. The 100 percent foil shield makes this coax cable low loss.The Times Microwave LMR-200 direct burial low loss RG58 coax cable is available in bulk and is priced per foot. Learn More

TIMES MICROWAVE LMR240-75 cable. 1/4" O.D. 75 ohms. Uses LMR240-75 connectors. .75" bending radius. Priced per ft. Learn More

TIMES MICROWAVE Indoor/Outdoor fire- retardant LMR-600 coaxial cable. PVC jacked. Black. CMR rated. Learn More

The Times Microwave LMR-100A-PVC-W LMR100 flexible, low loss coaxial cable (white) offers similar performance compared to corrugated copper cables but provides higher flexibility and simplified connectorization. This 50 Ohm coax cable has a stranded outer conductor and copper-clad steel center conductor. The 1/8 inch LMR-100 transmission line has a foil shield and 90 percent coverage braid shield for lower loss. A white PVC jacket adds flexibility and color compatibility for indoor applications. RG174 connectors should be used.The Times LMR-100 flexible, low loss coaxial cable is available in bulk and is priced per foot. Learn More

The Times Microwave LMR-240LL-PL orange plenum-rated low loss LMR-240 coaxial cable is an indoor, fire-retardant cable specifically designed for use in return air handling plenums. This braided coax cable offers similar performance compared to corrugated copper cables but provides high flexibility, simplified connectorization, and weatherproofing. It has a UL/NEC & CSA rating of 'CMP' and 'FT6' respectively. This 50 Ohm coax cable has a solid bare copper center conductor and aluminum taped outer conductor. Low loss is achieved through use of the 90 percent braided shield. A foam polyethylene serves as insulation. With higher flexibility, the LMR-240 cable has a bending radius of 3/4 inch.The LMR transmission line can be used in almost any application where handing characteristics, improved shielding, and low loss is required. The LMR-240 cable is similar in size to RG8X cables.The Times LMR-240 plenum-rated low loss coaxial cable is available in bulk and is priced per foot.This cable requires Times Microwave TC-240 series connectors. Learn More

The RFS ICA12-50JPL 1/2 inch plenum-rated coaxial cable features an air dielectric. The 50 Ohms coax cable has a blue jacket. This air dielectric cable has an annular corrugated copper outer conductor and copper-clad aluminum inner conductor. Maximum frequency capacity is 6.0 GHz. This transmission line uses 1/2 inch standard connectors.The RFS 1/2 inch plenum-rated coaxial cable with air dielectric is available in bulk and is priced per foot. Learn More

The RFS 810929-031 7/8 inch plenum-rated coaxial cable features an air dielectric. The 50 Ohms coax cable has a 10 inch bending radius per foot. This air dielectric cable has a helically-corrugated copper outer conductor and copper tube inner conductor. Maximum frequency capacity is 3.0 GHz. No automated prep tool is available for this transmission line -- air connectors are used.The RFS 7/8 inch plenum-rated coaxial cable with air dielectric is available in bulk and is priced per foot. Learn More

Times Microwave LMR square cut cable cutter is designed specifically for use on the entire range of LMR cables, from LMR-195 through LMR-600. This cable cutter tool quickly and easily square cuts the LMR cable end making it ready for connector termination. No metallic residue is left, eliminating the need for wire brushing. Safety locking mechanism keeps the tool positively closed until needed or when stored in a pouch. Streamlined designed fits more easily into a Times or other pouch. Times "blue" color replaces the old red color. Learn More

Times Microwave 1 meter TFT402 Jumper N Male to N Male. Learn More

TIMES No-Braid-Trim Advantage BNC male crimp connector for LMR-200 cable. Silver plated bodies, gold center pin. Solder center pin, crimp on braid (no braid trimming required). Learn More

The Times Microwave LMR-400 is a low loss braided coaxial cable. This 3/8 inch 50 Ohm coax cable has a stranded outer conductor and a bare copper center conductor. Learn More

Times Microwave combination manual cable preparation tool is made for use with 3/8 inch LMR-400 coaxial cable using crimp and clamp-style connectors. This cable hand prep tool joins a cable stripper tool and a cable trimming tool into one easy-to-use devicePrepare LMR-400 coax cable in two simple steps. First, insert the cable into side one, twist, cut, and expose the center conductor. Second, flip the tool around and insert the cable into side two. Twist and turn to expose the coax braid. This cable preparation tool has a built-in deburr tool and works with nearly all LMR-400 connectors. Learn More

TIMES MICROWAVE 20-1000 MHz general coverage bulkhead and flange mt. 10KA surge. <200uJ throughput energy. Power based on frequency. N female connectors. Learn More

TIMES MICROWAVE DC to 3.0 GHZ gas tube lightning arrestor. Passes up to +/- 90 VDC, 20A max. Bi-directional. Bulkhead mount. N/F Ant.-N/M Equip. Learn More

TIMES MICROWAVE .680-2.2 GHz DC Blocked Arrestor. N/F on antenna port, N/F on equipment port. Solid brass. Learn More

TIMES 7/16 DIN female connector for LMR400 coaxial cable. Solder center pin, clamp on braid. Learn More

RFS BA1010-1 omnidirectional fiberglass antenna operates in the 146 - 164 MHz frequency range. This unity gain VHF omni antenna is has a maximum power input of 500 watts and is terminated with an N female connector. This heavy-duty omnidirectional antenna is permanently affixed to a unique mounting fixture that allows for mounting either on top of or along side of most vertical supports. The RFS BA1010-1 omnidirectional fiberglass antenna includes a bracket and u-bolts for mounting. Learn More

The Times Microwave LMR240 low loss LMR-240 coaxial cable offers similar performance compared to corrugated copper cables but provides high flexibility and simplified connectorization. This 50 Ohm coax cable has a solid bare copper center conductor and stranded outer conductor that results in a 3/4 inch bending radius. Low loss is achieved through use of the 90 percent braided shield. A foam polyethylene serves as insulation. The LMR-240 transmission line can be used in almost any application where handing characteristics, improved shielding, and low loss is required. The LMR-240 cable is similar in size to RG8X cables and fits LMR-240 connectors.The Times LMR-240 low loss coaxial cable is available in bulk and is priced per foot. Learn More

7-16 DIN Female to N Male, 50 Ohm Learn More

Crimping tool for LMR-600 connectors Learn More

Auto trimming tool for ICA & LCF 12 Learn More

30' Ruggedized OS2 2F Riser Patch Cord LC to LC Learn More

TNC Male Crimp for LMR400 Cable Learn More

N Female for SCF12-50J Learn More

BNC Male (plug) crimp connector Learn More

Grounding Kit-1-1/4" =494677" Learn More

3/8 Low Loss Low Passive Intermod Coax In/Outdoor" Learn More

RFS 1/2" Radiating CELLFLEX Cable. 50 ohm. Fire ret. (type CATVX) jack. Utilizes standard LCF12-50J conn. Black jack. MSHA approved for use in Mines. Learn More

RFS ICA12-50JPLR Red 1/2" Plenum Air Coaxial Cable for Public Safety Applications. Learn More

Learn More

This special trimming tool improves the cable preparation prior to connector attachment. No further tools are required to prepare the cable for the connector attachment. This is due to the unique design of the trimming tool, which combines all necessary functions in one tool. It can be used for all CELLFLEX LCF12-50 foam dielectric cables in combination with the OMNI FIT Premium connector family D01, OMNI FIT Standard family B32 and RAPID FIT families 060/062 + 070/072. The Universal Trimming Tools Series offers the additional advantage to be convertible to different connector families and cable sizes (1/4", 3/8", 1/2" and 7/8") only by changing the insert. Learn More

RFS This special trimming tool improves the cable preparation prior to connector attachment. No furthertools are required to prepare the cable for the connector attachment. This is due to the unique design of the trimming tool, which combines all necessary functions in one tool. It can be used for CELLFLEX LCF78-50 foam dielectric cables in combination with the OMNI FIT Premium connector family D01. The Universal Trimming Tools Series offers the additional advantage to be convertible to different connector families and cable sizes (1/4", 3/8", 1/2" and 7/8") only by changing the insert. Learn More

7-16 DIN Male - N female Low Pim Adaptor Learn More

RFS TRIM-LCF12-D01-A is a Special trimming tool makes the OMNI FIT Premium D01 connector attachment easier. No further tools are required to prepare the cable for the connector attachment. This is due to the unique designof the trimming tool, which combines all necessary functions in one compact tool. It can be used for CELLFLEX LCF12-50 foam dielectric cables. Learn More